Manuals

(Assumes you're starting from factory settings)

Please note!

Only use this manual if you want to connect your own router behind the modem and put the modem in bridge mode. This modem can also be configured as a router — use the other manual for that.

Step 1: Log in

Log in via your web browser at http://192.168.1.1
Default Username and Password are both admin

Step 2: VLAN information

In the left menu, go to Internet Access > General Setup
Enable Enable on the Service side of VDSL2
The Tag Value must be set to 6.
Click Ok and ignore the reboot prompt that follows

P.S. You can also skip this step if you prefer. In that case, set your router's PPPoE interface to VLAN6 instead. Not every router supports this.

Step 3: Bridge settings

In the left menu, go to Internet Access > MPoA / Static or dynamic IP
Set MPoA (RFC1483/2684) to Enable
Under Bridge Mode, enable the Enable Bridge Mode option
Click OK and then reboot the modem.

You've now successfully configured your modem! You can now place your router behind the modem and configure it with the PPPoE details we provided.